Kernel driver ltc2990

Supported chips:

Author:

Description

LTC2990 is a Quad I2C Voltage, Current and Temperature Monitor. The chip’s inputs can measure 4 voltages, or two inputs together (1+2 and 3+4) can be combined to measure a differential voltage, which is typically used to measure current through a series resistor, or a temperature with an external diode.

Usage Notes

This driver does not probe for PMBus devices. You will have to instantiate devices explicitly.

Sysfs attributes

in0_input

Voltage at Vcc pin in millivolt (range 2.5V to 5V)

temp1_input

Internal chip temperature in millidegrees Celsius

A subset of the following attributes are visible, depending on the measurement mode of the chip.

in[1-4]_input

Voltage at V[1-4] pin in millivolt

temp2_input

External temperature sensor TR1 in millidegrees Celsius

temp3_input

External temperature sensor TR2 in millidegrees Celsius

curr1_input

Current in mA across V1-V2 assuming a 1mOhm sense resistor

curr2_input

Current in mA across V3-V4 assuming a 1mOhm sense resistor

The “curr*_input” measurements actually report the voltage drop across the input pins in microvolts. This is equivalent to the current through a 1mOhm sense resistor. Divide the reported value by the actual sense resistor value in mOhm to get the actual value.