Kernel driver ntc_thermistor

Supported thermistors from Murata:

• Murata NTC Thermistors NCP15WB473, NCP18WB473, NCP21WB473, NCP03WB473, NCP15WL333, NCP03WF104, NCP15XH103

  Prefixes: ‘ncp15wb473’, ‘ncp18wb473’, ‘ncp21wb473’, ‘ncp03wb473’, ‘ncp15wl333’, ‘ncp03wf104’, ‘ncp15xh103’

  Datasheet: Publicly available at Murata

Supported thermistors from EPCOS:

• EPCOS NTC Thermistors B57330V2103

  Prefixes: b57330v2103

  Datasheet: Publicly available at EPCOS

Other NTC thermistors can be supported simply by adding compensation tables; e.g., NCP15WL333 support is added by the table ncpXXwl333.

Authors:

MyungJoo Ham <myungjoo.ham@samsung.com>

Description

The NTC (Negative Temperature Coefficient) thermistor is a simple thermistor that requires users to provide the resistance and lookup the corresponding compensation table to get the temperature input.

The NTC driver provides lookup tables with a linear approximation function and four circuit models with an option not to use any of the four models.

Using the following convention:

$    resistor
[TH] the thermistor

The four circuit models provided are:

1. connect = NTC_CONNECTED_POSITIVE, pullup_ohm > 0:

   [pullup_uV]
       |    |
      [TH]  $ (pullup_ohm)
       |    |
       +----+-----------------------[read_uV]
       |
       $ (pulldown_ohm)
       |
      -+- (ground)
   

2. connect = NTC_CONNECTED_POSITIVE, pullup_ohm = 0 (not-connected):

   [pullup_uV]
       |
      [TH]
       |
       +----------------------------[read_uV]
       |
       $ (pulldown_ohm)
       |
      -+- (ground)
   

3. connect = NTC_CONNECTED_GROUND, pulldown_ohm > 0:

   [pullup_uV]
       |
       $ (pullup_ohm)
       |
       +----+-----------------------[read_uV]
       |    |
      [TH]  $ (pulldown_ohm)
       |    |
      -+----+- (ground)
   

4. connect = NTC_CONNECTED_GROUND, pulldown_ohm = 0 (not-connected):

   [pullup_uV]
       |
       $ (pullup_ohm)
       |
       +----------------------------[read_uV]
       |
      [TH]
       |
      -+- (ground)
   

When one of the four circuit models is used, read_uV, pullup_uV, pullup_ohm, pulldown_ohm, and connect should be provided. When none of the four models are suitable or the user can get the resistance directly, the user should provide read_ohm and _not_ provide the others.

Sysfs Interface

name		the mandatory global attribute, the thermistor name.
temp1_type	RO	always 4 (thermistor)
temp1_input	RO	measure the temperature and provide the measured value. (reading this file initiates the reading procedure.)

Note that each NTC thermistor has only _one_ thermistor; thus, only temp1 exists.