powerline-config manual page¶

Synopsis¶

powerline-config [-pPATH]… tmux ACTION ( [-s |n )]
powerline-config [-pPATH]… shell ACTION [COMPONENT] [-sSHELL]

-p, --config-path PATH: Path to configuration directory. If it is present then configuration files will only be sought in the provided path. May be provided multiple times to search in a list of directories.
-h, --help: Display help and exit.

ACTION: If action is source then version-specific tmux configuration files are sourced, if it is setenv then special (prefixed with _POWERLINE) tmux global environment variables are filled with data from powerline configuration. Action setup is just doing setenv then source.
-s, --source: When using setup: always use configuration file sourcing. By default this is determined automatically based on tmux version: this is the default for tmux 1.8 and below.
-n, --no-source: When using setup: in place of sourcing directly execute configuration files. That is, read each needed powerline-specific configuration file, substitute $_POWERLINE_… variables with appropriate values and run tmux config line. This is the default behaviour for tmux 1.9 and above.
-h, --help: Display help and exit.

ACTION: If action is command then preferred powerline command is output, if it is uses then powerline-config script will exit with 1 if specified component is disabled and 0 otherwise.
COMPONENT: Only applicable for uses subcommand: makes powerline-config exit with 0 if specific component is enabled and with 1 otherwise. tmux component stands for tmux bindings (e.g. those that notify tmux about current directory changes), prompt component stands for shell prompt.
-s, --shell SHELL: Shell for which query is run
-h, --help: Display help and exit.

Written by Kim Silkebækken, Nikolay Pavlov, Kovid Goyal and contributors. The glyphs in the font patcher are created by Fabrizio Schiavi.