Next: , Previous: , Up: Updating Nodes and Menus   [Contents][Index]


D.5.2 Updating Requirements

To use the updating commands, you must organize the Texinfo file hierarchically with chapters, sections, subsections, and the like. When you construct the hierarchy of the manual, do not ‘jump down’ more than one level at a time: you can follow the ‘Top’ node with a chapter, but not with a section; you can follow a chapter with a section, but not with a subsection. However, you may ‘jump up’ any number of levels at one time—for example, from a subsection to a chapter.

Each @node line, with the exception of the line for the ‘Top’ node, must be followed by a line with a structuring command such as @chapter, @section, or @unnumberedsubsec.

Each @node line/structuring-command line combination must look either like this:

@node     Comments,  Minimum, Conventions, Overview
@comment  node-name, next,    previous,    up
@section Comments

or like this (without the @comment line):

@node Comments, Minimum, Conventions, Overview
@section Comments

or like this (without the explicit node pointers):

@node Comments
@section Comments

In this example, ‘Comments’ is the name of both the node and the section. The next node is called ‘Minimum’ and the previous node is called ‘Conventions’. The ‘Comments’ section is within the ‘Overview’ node, which is specified by the ‘Up’ pointer. (Instead of an @comment line, you may also write an @ifinfo line.)

If a file has a ‘Top’ node, it must be called ‘top’ or ‘Top’ and be the first node in the file.

The menu updating commands create a menu of sections within a chapter, a menu of subsections within a section, and so on. This means that you must have a ‘Top’ node if you want a menu of chapters.

Incidentally, the makeinfo command will create an Info file for a hierarchically organized Texinfo file that lacks ‘Next’, ‘Previous’ and ‘Up’ pointers. Thus, if you can be sure that your Texinfo file will be formatted with makeinfo, you have no need for the update node commands. (See Creating an Info File, for more information about makeinfo.)


Next: Other Updating Commands, Previous: The Updating Commands, Up: Updating Nodes and Menus   [Contents][Index]